1.2.3.12
	- support for OpenVox IPC1XX
	- system detects Alix or OpenVox card on first boot and installs correct config
	- support for 5 ethernet ports

1.2.3.11
	- interim release for OpenVox IPC1XX

1.2.3.10
	- Cleand up many HTML and Javascript display issues
	- fixed bug in firewal rules which would not allow selecting WAN as gateway

1.2.3.9
	- Added manual failover
	- Added gui for PPP dialup

1.2.3.8 
	- Fixed extra calls to DHCP config when hot plugging WAN2
	- put a guard in proxy_monitory.sh to prevent multiple copies of the scrip from running
	- modified help text in system.php

1.2.3.7
	- DHCP now works correctly for WAN/WAN2 when WXA is booted before DHCP server. Prior to this build WXA had to be
		booted after the DHCP server was running if DHCP was configured for WAN and/or WAN2
	- Logout pop screen for captiveportal now works on all web browsers
	- Added 2 more DNS server slots under system->general
	- Added the ability to statically route DNS servers through specific WAN without having to add routes manually
	- Added create clone/backup image to USB drive. The image can be restored by selecting it when doing firmware upgrade from USB 

1.2.3.6
	- Maximum/Minimum compression now select the correct compression level. in 1.2.3.5 Max/Min were transposed. 
	- rules added to proxy server to allow block filter messages to be displayed back to the user when in failsafe/load balancing mode
	- added firmware update feature to webadmin under system->firmware
	- added automatic firmware version checker and update to firmware and server

1.2.3.5 
	- Initial default configuration is now correctly initialized.
	- fixed bug in captive portal that prevented accounting updates to be sent to failover RADIUS server
	- reduced delay when reporting captive portal accounting data to backup RADIUS server.  Updates now take 1 min 10 seconds. 
		Updates take 1 minute on primary RADIUS sever.

1.2.3.4
	- fixed a bug in apinger which would cause the failover and load balancing pools to stop working after a while.
	- ntpclient now starts up at boot time when checked in the general tab.
	- set the ntp client enabled to be default.
	- firmware upgrade from USB now work on FAT32 formated USB drives with/without boot partition.
	- compression proxy configuration simplified.
	- simplified load balancing and failover configuration for compression proxy.
	- same firmware image can now be used on wifi/wired versions.
	- ping interval for testing network interfaces for failover/load balancing changed from 1 per second to 1 every 10 seconds.
		failovers now occur up to 20 seconds after interface failure detection.
	- captive portal configuration modified to more easily support load balancing/failover configurations.
	- updated squidGuard which now includes a log interface page.
	- Admin web interface should now work with version of Microsoft Internet Explorer < 7.0.
	- Web Admin system status now shows booting status.  The unit should not be userd or configured until status displays.
		Operational.
1.2.3.3 
	- added check to enable/disable ntp client in system->general.
	- modified factory defaults routine to select appropriate default based on hardware.
	- removed option to unselect packages when backing up.
	- removed bogus failover pool from config.
1.2.3.2
	- Added firmware updates.
	- fixed issue when which broke packages when uploading saved config.xml file.
1.2.3
	- Initial release.